REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
6. REMOVE REAR SPEAKER ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 3 bolts and rear speaker assembly.
7. REMOVE REAR SPEAKER BRACKET (for 13 Speakers)
(a) Remove the 8 screws, rear speaker bracket and rear door speaker grille sub-assembly. |
|
8. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 13 Speakers)
(a) Remove the 2 screws. |
|
(b) Disengage the clamp and remove the rear No. 2 speaker assembly.
Front Door Speaker
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system (Se ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT INTEGRATION RELAY
(a) Inner circuit (for 2GR-FE)
(1) for EFI MAIN relay
Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Do not remove the steering angle sensor from the spiral cable.
HINT:
The steering angle sensor is a component of the spiral with sensor cable sub-assembly.
If the steering angle sensor malfunctions, replace the sp ...