REMOVAL
PROCEDURE
1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
3. REMOVE NO. 2 CONSOLE BOX CARPET
4. REMOVE CONSOLE BOX ASSEMBLY
5. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
6. REMOVE FRONT DOOR SCUFF PLATE RH
7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
11. REMOVE POSITION INDICATOR HOUSING ASSEMBLY
12. REMOVE CONSOLE BOX SUB-ASSEMBLY
13. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
14. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(a) Remove the 4 bolts. |
|
(b) Disengage the 2 clips.
(c) Disconnect each connector and remove the radio and display receiver assembly with bracket.
15. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
(a) Remove the 4 screws. |
|
(b) Disengage the 4 claws and remove the instrument cluster center finish panel sub-assembly. |
|
16. REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)
17. REMOVE NO. 1 RADIO RECEIVER BRACKET
(a) Remove the 4 screws and No. 1 radio receiver bracket. |
|
18. REMOVE NO. 2 RADIO RECEIVER BRACKET
(a) Remove the 4 screws and No. 2 radio receiver bracket. |
|
19. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
Front seats
► Power seat
1. Seat position fore/aft control switch
2. Seatback angle control switch
3. Seat cushion (front) angle control switch (driver’s side only)
4. Vertical height control switch (driver’s side only)
5. Lumbar support control switch
& ...
Lost Communication with Front Airbag Sensor RH (B1612/83,B1613/83)
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor assembly
and front airbag sensor RH.
The front airbag sensor RH detects impacts to the vehicle and sends signals to
the center airbag sensor assembly to determine if the ...
Removal
REMOVAL
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
(See page ).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
3. REMO ...