REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page ).
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page ).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER
(a) Disengage the claw and guide to remove the lower No. 3 steering wheel cover. |
|
4. REMOVE LOWER NO. 2 STEERING WHEEL COVER
(a) Disengage the claw and guide to remove the lower No. 2 steering wheel cover. |
|
5. REMOVE STEERING PAD
CAUTION:
When storing the steering pad, keep the airbag deployment side facing upward.
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Using a screwdriver, push up the torsion spring to disengage the pin. Text in Illustration
HINT: Insert the screwdriver from the installation hole of the lower No. 3 steering wheel cover. |
|
(d) Using a screwdriver, push in the 2 torsion springs to disengage the 2 pins. Text in Illustration
NOTICE: Do not drop the steering pad. HINT: Insert the screwdriver from the installation holes in the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover. |
|
(e) Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.
(f) Disconnect the horn connector from the steering pad. |
|
(g) Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
Text in Illustration
*1 |
Protective Tape |
*2 |
Airbag Connector |
*3 |
Horn Connector |
*4 |
Airbag Connector Lock |
(h) Disconnect the 2 airbag connectors to remove the steering pad.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLING FAN MOTOR
(a) Check that the motor operates smoothly when the battery is connected
to the cooling fan motor connector.
Text in Illustration
*1
Componen ...
Tire Pressure Warning Ecu
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter
IDs of all wheels and write them down to use for re-registration of ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the rear
airbag sensor.
PROCEDURE
1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic sys ...