Toyota Venza: Removal

Toyota Venza Service Manual / Supplemental Restraint Systems / Front Seat Side Airbag Assembly / Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page ).

If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly with adjuster, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

(See page )

3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

(See page )

4. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY (for Manual Seat)

5. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY (for Power Seat)

6. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

7. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)

8. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY

(a) Disengage the 4 clamps and disconnect the wire harness.

Text in Illustration

*A	for Manual Seat
*B	for Power Seat

(b) Disengage the 2 clamps and disconnect the wire harness.

CAUTION:

The nuts must not be reused.
Make sure that the front seat frame assembly with adjuster is not deformed. If it is, replace it with a new one.

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat side airbag assembly. PROCEDURE 1. INSPECT FRONT SEAT ...

Disposal

DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations ...

Other materials about Toyota Venza:

Lost Communication with "Door Control Module A" (U0199)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area U0199 No communication from the outer mirror control ECU (for front passenger side) continues. Outer mirror control ...

Black Screen
PROCEDURE 1. CHECK DISPLAY SETTING (a) Check that the display is not in screen off mode. OK: The display setting is not in screen off mode. NG CHANGE SCREEN TO SCREEN ON MODE ...

Microphone Circuit between Microphone and Navigation Receiver Assembly
DESCRIPTION The navigation receiver assembly and inner rear view mirror assembly (amplifier microphone assembly) are connected to each other using the microphone connection detection signal lines. Using this circuit, the navigation receiver ...