Toyota Venza: Removal

Toyota Venza Service Manual / Seat Belt / Rear Seat Inner Belt Assembly(for Rh Side) / Removal

REMOVAL

PROCEDURE

1. REMOVE REAR SEAT HEADREST ASSEMBLY

2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

3. REMOVE REAR SEAT INNER TRACK BRACKET COVER

4. REMOVE REAR SEAT OUTER TRACK BRACKET COVER

5. DISCONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY

6. REMOVE REAR SEAT ASSEMBLY RH

7. REMOVE SEAT ADJUSTER COVER CAP RH

8. REMOVE REAR SEAT RECLINING RELEASE LEVER RH

9. REMOVE REAR SEAT RECLINING COVER RH

10. REMOVE CENTER SEAT HINGE COVER RH

11. REMOVE REAR SEAT INNER RECLINING COVER RH

12. REMOVE REAR SEAT CENTER ARMREST ASSEMBLY

13. REMOVE REAR SEAT CUSHION COVER WITH PAD

14. REMOVE REAR SEAT INNER BELT ASSEMBLY RH

(a) Remove the bolt and the rear seat inner belt assembly RH.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY RH (a) Install the rear seat inner belt assembly RH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} ...

Other materials about Toyota Venza:

Moon roof
Use the overhead switches to open, close, and tilt the moon roof up and down. - Opening and closing 1. Open The moon roof stops slightly before the fully open position to reduce wind noise. Move the switch backward again to fully open. 2. Close ( ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the T ...

Installation
INSTALLATION PROCEDURE 1. INSTALL DRIVE MONITOR SWITCH (a) Engage the 4 claws to install the driver monitor switch. 2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display ...