REMOVAL
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
(a) Press the headrest support button and pull up the headrest as shown in the illustration to remove it. |
|
2. REMOVE REAR SEAT INNER TRACK BRACKET COVER
(a) Disengage the 3 claws and guide, and remove the rear seat inner track bracket cover as shown in the illustration. |
|
3. REMOVE REAR SEAT OUTER TRACK BRACKET COVER
(a) Disengage the 3 claws and guide, and remove the rear seat outer track bracket cover as shown in the illustration. |
|
4. DISCONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY
(a) Pull down the adjuster's lock piece to release the lock as shown in the illustration.
Text in Illustration
*1 |
Adjuster Spring |
*2 |
Lock Piece |
(b) Using a screwdriver wrapped with protective tape, disengage the 2 claws as shown in the illustration. Text in Illustration
|
|
(c) Lift up the seat track adjusting handle to the uppermost position and hold the handle in this position as shown in the illustration.
Text in Illustration
*1 |
Seat Track Adjusting Handle |
*2 |
Protective Tap |
(d) Using a screwdriver wrapped with protective tape, disconnect the rear seat reclining control cable sub-assembly as shown in the illustration.
Text in Illustration
*1 |
Protective Tape |
(e) Secure the rear seat No. 2 reclining control cable sub-assembly with the carpet hole as shown in the illustration.
5. REMOVE REAR SEAT ASSEMBLY LH
(a) Remove the 2 bolts on the rear side of the seat. |
|
(b) Remove the 2 bolts on the front side of the seat. |
|
(c) Remove the rear seat assembly LH.
NOTICE:
Be careful not to damage the vehicle body.
Brake Signal Malfunction (B2284)
DESCRIPTION
The power management control ECU receives brake signal information from 2 sources.
It receives a signal from the stop light switch assembly via a direct line, and
a signal from the ECM via CAN. If the information from these 2 sources is incons ...
A/C ECU Vehicle Information Reading/Writing Processor Malfunction (B15F5)
DESCRIPTION
This DTC is stored when items controlled by the air conditioning amplifier assembly
cannot be customized via the navigation system vehicle customization screen.
HINT:
The air conditioning amplifier assembly controls the air conditioning system ...
Initialization
INITIALIZATION
1. RESET BACK DOOR CLOSE POSITION
NOTICE:
Perform initialization of the power back door system (power back door ECU initialization)
if one of the following is performed:
The cable is disconnected from the negative (-) battery termin ...