Toyota Venza manuals

Toyota Venza: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE FRONT SEAT REAR OUTER TRACK COVER


3. REMOVE FRONT SEAT REAR INNER TRACK COVER


4. REMOVE FRONT SEAT ASSEMBLY


5. REMOVE RECLINING POWER SEAT SWITCH KNOB


6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


7. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY


8. REMOVE FRONT POWER SEAT LUMBAR SWITCH

(a) Remove the 2 screws and the front power seat lumbar switch.


Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection
INSPECTION PROCEDURE 1. INSPECT DRIVER SIDE LUMBAR SWITCH (a) Measure the resistance between the terminals when the switch is operated. Standard Resistance: Teste ...

Other materials about Toyota Venza:

Throttle / Pedal Position Sensor "A" Minimum Stop Performance (P2109)
DESCRIPTION The idle speed is controlled by the Electronic Throttle Control System (ETCS). The ETCS is comprised of a throttle actuator, which operates the throttle valve, and a throttle position sensor, which detects the opening amount of the throttle ...

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle.  - Correct use of the seat belts 1. Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the clearance sonar main switch on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Intuitive P/A / DTC. (f) ...

© 2016-2024 Copyright www.tovenza.com

0.1725