Toyota Venza manuals

Toyota Venza: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

  • Be sure to read Precaution thoroughly before servicing (See page ).

  • If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly with adjuster, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


3. REMOVE FRONT SEAT HEADREST ASSEMBLY

4. REMOVE FRONT SEAT REAR OUTER TRACK COVER

(a) Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.

(b) Disengage the 2 claws and remove the front seat rear outer track cover.


5. REMOVE FRONT SEAT REAR INNER TRACK COVER

(a) Disengage the 2 claws and remove the front seat rear inner track cover.


6. REMOVE FRONT SEAT ASSEMBLY

(a) Remove the 2 bolts on rear side of the front seat assembly.


(b) Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.

(c) Remove the 2 bolts on front side of the front seat assembly.


(d) Lift up the seat track adjusting handle and move the front seat assembly to the center position. Also, operate the reclining adjuster release handle and move the front seatback assembly to the upright position.

(e) Disconnect each connector under the front seat assembly.

(f) Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SEAT WIRE (a) Engage the 2 clamps to install the front seat wire. (b) Connect the 4 connectors. 2. ...

Other materials about Toyota Venza:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is displayed during the DTC check, check the trouble areas listed for that code in the table below and proceed to the appropriate page. Cruise Control System DTC Code Detection Item ...

Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)
DESCRIPTION The DTCs are stored when the CAN communication system is malfunctioning. DTC No. DTC Detection Condition Trouble Area U0101 Lost communication with ECM CAN communication syst ...

Motor Circuit Malfunction (C1522-C1555)
DESCRIPTION The power steering ECU supplies current to the power steering motor through the motor circuit. DTC No. DTC Detection Condition Trouble Area C1522 Motor current sensor malfunction ...

© 2016-2024 Copyright www.tovenza.com

0.1228