Toyota Venza: Removal

Toyota Venza Service Manual / Power Outlets (int) / Power Outlet Socket / Removal

REMOVAL

PROCEDURE

1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

3. REMOVE NO. 2 CONSOLE BOX CARPET

4. REMOVE CONSOLE BOX ASSEMBLY

5. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

6. REMOVE FRONT DOOR SCUFF PLATE LH

7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

9. REMOVE FRONT DOOR SCUFF PLATE RH

10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

13. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

14. REMOVE POSITION INDICATOR HOUSING ASSEMBLY

15. REMOVE CONSOLE BOX SUB-ASSEMBLY

16. REMOVE POWER POINT SOCKET ASSEMBLY

(a) Using a screwdriver, disengage the 2 claws and remove the power point socket assembly as shown in the illustration.

Text in Illustration

*1	Protective Tape

HINT:

Tape the screwdriver tip before use.

17. REMOVE POWER OUTLET SOCKET COVER NO.1

(a) Disengage the 2 claws and remove the power point socket cover.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Installation

INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET COVER NO.1 (a) Engage the 2 claws to install the power point socket cover. 2. INSTAL ...

Other materials about Toyota Venza:

Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) (P0741)
SYSTEM DESCRIPTION The TCM uses signals from the throttle position sensor, air-flow meter, turbine (input) speed sensor, intermediate (counter gear) speed sensor and crankshaft position sensor to help determine the engagement timing of the lock-up clutch. ...

Test Mode Procedure
TEST MODE PROCEDURE 1. DESCRIPTION HINT: When using a chassis dynamometer, brake tester, etc. to perform a vehicle test, activate test mode to avoid a "different tire diameter installed" incorrect judgment. Test mode does not have a AWD paramet ...

CD Sound Skips
PROCEDURE 1. CHECK CD (a) Check that the CD is not deformed or cracked. OK: No deformation or cracks on the CD. NG END (CD IS FAULTY) ...