REMOVAL
PROCEDURE
1. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER
(a) Disengage the 2 claws and slide the inner rear view mirror stay holder cover as shown in the illustration. |
|
(b) Disengage the 2 claws and remove the inner rear view mirror stay holder cover. |
|
2. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System)
(a) Disconnect the connector. |
|
(b) Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror assembly.
3. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System)
NOTICE:
(a) Disconnect the connector. |
|
(b) Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror assembly.
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
ACC Monitor Malfunction (B2274)
DESCRIPTION
This DTC is stored when there is a problem in the ACC output circuit. The ACC
circuit is the circuit that goes from inside the power management control ECU to
the ACC relay.
DTC No.
DTC Detection Condition
Tro ...
Precaution
PRECAUTION
1. PRECAUTION FOR VEHICLE WITH SRS AIRBAG AND SEAT BELT PRETENSIONER
(a) Some operations in this section may affect the SRS airbags. Prior to performing
the corresponding operations, read the precautions regarding the SRS airbags (See
page ). ...