REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
3. REMOVE COOL AIR INTAKE DUCT SEAL
4. REMOVE RADIATOR GRILLE
5. REMOVE INLET NO. 2 AIR CLEANER
6. REMOVE AIR CLEANER CAP WITH HOSE
7. REMOVE AIR CLEANER CASE
8. REMOVE BATTERY
9. REMOVE INLET NO. 1 AIR CLEANER
10. REMOVE LOW PITCHED HORN ASSEMBLY
11. REMOVE HIGH PITCHED HORN ASSEMBLY
12. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
13. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
14. REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY
(a) Disengage each clamp. |
|
(b) Remove the 2 bolts and hood lock support support sub-assembly. |
|
15. REMOVE UPPER RADIATOR SUPPORT
16. DISCONNECT COOLER REFRIGERANT DISCHARGE HOSE
(a) Remove the bolt and disconnect the cooler refrigerant discharge hose from the condenser. |
|
(b) Remove the O-ring from the cooler refrigerant discharge hose.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
17. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
(a) Remove the bolt and disconnect the air conditioning tube and accessory assembly. |
|
(b) Remove the O-ring from the air conditioning tube and accessory assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
18. REMOVE COOLER CONDENSER ASSEMBLY
(a) Remove the 4 bolts and cooler condenser assembly as shown in the illustration. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY
(a) Insert the front end of the front door outside handle assembly into
the front door outside handle frame.
(b) Insert the r ...
Check CAN Bus Lines for Short Circuit
DESCRIPTION
There may be a short circuit in the CAN bus main wire and/or CAN branch wire
when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below
54 Ω.
Symptom
Trouble Area
Resistance betwe ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the LIN communication system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...