Toyota Venza: Removal

Toyota Venza Service Manual / Door Lock / Rear Door Lock / Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

6. REMOVE REAR DOOR SERVICE HOLE COVER

7. REMOVE REAR DOOR GLASS RUN

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

10. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the 3 screws.

(b) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(d) Using a screwdriver, disengage the claw.

HINT:

Tape the screwdriver tip before use.

(e) Remove the rear door lock remote control cable assembly from the rear door lock assembly.

(f) Using a screwdriver, disengage the 3 claws.

HINT:

Tape the screwdriver tip before use.

(g) Remove the rear door inside locking cable assembly from the rear door lock assembly.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR DOOR LOCK ASSEMBLY LH (a) Check the operation of the door lock motor. (1) Apply battery voltage and check the operation of the door lock motor. O ...

Other materials about Toyota Venza:

Test Mode Procedure
TEST MODE PROCEDURE 1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK (a) Release the parking brake. NOTICE: Before releasing the parking brake, move the shift lever to P for safety. HINT: When the parking brake is applied or the brake fluid level is lo ...

Removal
REMOVAL PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (a) Remove the engine and transaxle (See page ). 2. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (a) Remove the exhaust manifold converter (See page ). 3. REMOVE THROTTLE BODY ASSEMBLY ...

Engine Control System Malfunction (C1201/51)
DESCRIPTION If a malfunction in the engine control system is detected, the operations of VSC and TRAC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is cancelled and the DTC is not stored. ...