REMOVAL
PROCEDURE
1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY
2. REMOVE REAR WIPER ARM HEAD CAP
(a) Disengage the 4 claws and remove the rear wiper arm head cap as shown in the illustration. |
|
3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
(a) Remove the nut and the rear wiper arm and blade assembly. |
|
4. REMOVE REAR WIPER MOTOR GROMMET
(a) Remove the rear wiper motor grommet. |
|
5. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 3 bolts and the rear wiper motor and bracket assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR TRANSPONDER KEY ECU DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
(e) Check the det ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2F and 2C driver side junction block connectors.
(b) Disconnect the D50 and D51 main body ECU connectors.
(c) Measure the resistance and voltage according to ...