REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
(a) Remove the front part of the front door opening trim weatherstrip to the extent that allows removal of the front pillar garnish.
2. REMOVE FRONT PILLAR GARNISH
3. REMOVE FRONT PILLAR GARNISH CORNER PIECE (for 6 Speakers)
4. REMOVE FRONT PILLAR GARNISH CORNER PIECE (for 13 Speakers)
5. REMOVE FRONT SIDE FIX WINDOW ASSEMBLY
(a) Apply protective tape to the installation position of the front side fix window assembly on the vehicle body. Text in Illustration
|
|
(b) Place matchmarks on the front side fix window assembly and vehicle body on the locations indicated in the illustration. Text in Illustration
HINT: Matchmarks are not necessary if the front side fix window assembly is not going to be reused. |
|
(c) Pass a piano wire between the interior vehicle body and glass from the interior as shown in the illustration. HINT: Do not allow the piano wire to interfere with the clips. |
|
(d) Tie both wire ends to wooden blocks or similar objects that can serve as handles.
NOTICE:
When separating the front side fix window assembly from the vehicle, be careful not to damage the paint or interior and exterior ornaments.
(e) Cut off the adhesive by pulling the piano wire around the front side fix window assembly.
NOTICE:
Leave as much adhesive on the vehicle body as possible when cutting through the adhesive.
(f) Disengage the 3 clips. |
|
(g) Using suction cups, remove the glass.
NOTICE:
Be careful not to drop the glass.
6. CLEAN VEHICLE BODY
(a) Clean and shape the contact surfaces of the vehicle body. Text in Illustration
(1) Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration. NOTICE: Be careful not to damage the vehicle body. HINT: Leave as much adhesive on the vehicle body as possible. |
|
(b) Clean the contact surfaces of the vehicle body with a piece of cloth saturated with cleaner.
HINT:
Even if all the adhesive has been removed, clean the vehicle body.
Adjusting the settings
- Adjusting the temperature setting
Turn the temperature control dial clockwise (warm) or counterclockwise (cool).
The air conditioning system switches between dual and simultaneous modes each
time is pressed.
Each temperature setting will be displ ...
Black Screen
PROCEDURE
1.
CHECK DISPLAY SETTING
(a) Check that the display is not in screen off mode.
OK:
The display setting is not in screen off mode.
NG
CHANGE SCREEN TO SCREEN ON MODE
...
AWD Warning Light Remains ON
DESCRIPTION
The AWD control ECU is connected to the combination meter via the CAN communication
system.
If the AWD control ECU stores any DTCs which are related to the active torque
control 4WD system, the AWD warning light comes on in the combination me ...