REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page ).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
6. REMOVE COURTESY LIGHT ASSEMBLY
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
8. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
9. REMOVE DOOR SIDE AIRBAG SENSOR
10. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Memory)
11. REMOVE FRONT DOOR SERVICE HOLE COVER
12. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(a) Remove the hole plug. |
|
(b) Disconnect the connector. |
|
(c) Remove the 3 nuts.
(d) Disengage the 3 claws and remove the outer rear view mirror assembly as shown in the illustration. |
|
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT DOOR LOCK ASSEMBLY LH
(a) Check the operation of the door lock motor.
(1) Apply battery voltage and check the operation of the door lock motor.
OK:
Measurement Condition
...
Removal
REMOVAL
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See page
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
3. REMOVE W ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...