REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. PRECAUTION (for HID Headlight)
(See page )
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page ).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
3. REMOVE FRONT BUMPER ASSEMBLY
(See page )
4. REMOVE HEADLIGHT ASSEMBLY
(a) Remove the bolt and 3 screws. |
|
(b) Disconnect each connector and remove the headlight assembly.
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION OF SYSTEM
(a) Each tire pressure warning valve and transmitter is equipped with a tire
pressure sensor and a transmitter and is installed in each tire and wheel assembly.
The sensor measures the tire pressure. The measur ...
Compressor Lock Sensor Circuit (B1422/22)
SYSTEM DESCRIPTION
The ECM sends the engine speed signal to the A/C amplifier via CAN communication.
The A/C amplifier reads the difference between compressor speed and engine speed.
When the difference becomes too large, the A/C amplifier determines that ...
Front Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WIPER BLADE
(a) Remove the holder of the front wiper blade.
(b) Remove the front wiper blade from the f ...