Toyota Venza: Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF DRIP CENTER SIDE FINISH MOULDING (w/o Sliding Roof)
|
(a) Put protective tape around the roof drip center side finish moulding. Text in Illustration
|
|
|
(b) Using a moulding remover, disengage the 2 clips and remove the roof drip center side finish moulding. NOTICE:
|
|
2. REMOVE ROOF DRIP CENTER SIDE FINISH MOULDING (w/ Sliding Roof)
|
(a) Put protective tape around the roof drip center side finish moulding. Text in Illustration
|
|
|
(b) Using a moulding remover, disengage the 2 clips and remove the roof drip center side finish moulding. NOTICE:
|
|
Components
COMPONENTS
ILLUSTRATION
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (w/o Sliding Roof)
NOTICE:
If reusing the clips, do not remove the double-sided tape remaining
on the clips and wh ...
Other materials about Toyota Venza:
XM Tuner Malfunction (B15BA)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the stereo component tuner
assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15BA
When either of the following conditions is m ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and
other items to be operated without removing any parts. This non-intrusive functional
inspection can be very useful because inter ...
Diagnosis System
DIAGNOSIS SYSTEM
1. ECUS OR SENSORS WHICH COMMUNICATE THROUGH CAN COMMUNICATION SYSTEM
(a) CAN No. 1 Bus
(1) ECM
(2) Main body ECU (Driver side junction block)
(3) Combination meter
(4) Power steering ECU
(5) Air conditioning amplifier*3
(6) Center air ...
0.1736