Toyota Venza: Removal

Toyota Venza Service Manual / Exterior Panels / Trim / Front Door Belt Moulding / Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

5. REMOVE COURTESY LIGHT ASSEMBLY

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

7. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

8. REMOVE DOOR SIDE AIRBAG SENSOR

9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

10. REMOVE FRONT DOOR SERVICE HOLE COVER

11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

12. REMOVE FRONT DOOR GLASS RUN

13. REMOVE FRONT DOOR BELT MOULDING

(a) Put protective tape around the front door belt moulding.

Text in Illustration

*1	Protective Tape

(b) Using a clip remover, remove the clip.

Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT DOOR BELT MOULDING (a) Engage the 5 claws to install the front door belt moulding. (b) Install the ...

Front Door Window Frame Moulding

...

Other materials about Toyota Venza:

Blower Motor Circuit
DESCRIPTION The blower motor is operated by signals from the A/C amplifier. Blower motor speed signals are transmitted in accordance with changes in the duty ratio. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related ...

No Sound can be Heard from Speakers
PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio system returns to normal. HINT: Sound quality adjustment mea ...

Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION The No. 1 ultrasonic sensor (rear left center sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear left center sensor). If the No. 1 ultrasonic sensor (rear left ce ...