REMOVAL
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
(a) Using a clip remover, remove the 12 clips and cool air intake duct seal. |
|
2. REMOVE RADIATOR GRILLE
3. REMOVE FRONT BUMPER ASSEMBLY
(a) Put protective tape around the front bumper assembly. Text in Illustration
|
|
(b) Remove the 2 bolts and 6 screws. |
|
(c) Using a clip remover, remove the clip.
(d) Remove the screw. HINT: Use the same procedure for the RH side and LH side. |
|
(e) Using a screwdriver, turn the 2 pins 90 degrees and remove the 2 pin hold clips. HINT: Use the same procedure for the RH side and LH side. |
|
(f) Disengage the 4 claws and remove the front bumper assembly. HINT: Use the same procedure for the RH side and LH side. |
|
(g) Disconnect each connector.
(h) Remove the front bumper assembly as shown in the illustration. |
|
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
Blind Spot Mirrors
The Blind Spot Mirrors increase the view of surrounding area to assist the driver
when checking surrounding area before changing lanes.
1. Blind Spot Mirror field of view
2. Main mirror field of view
- Mirror angle can be adjusted when
►V ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...