REMOVAL
PROCEDURE
1. REMOVE REAR DOOR SCUFF PLATE LH
2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
4. REMOVE DECK BOARD ASSEMBLY
5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
6. REMOVE DECK SIDE TRIM BOX LH
7. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY
8. REMOVE DECK SIDE TRIM BOX RH
9. REMOVE NO. 1 DECK BOARD
10. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY
11. REMOVE REAR FLOOR FINISH PLATE
12. REMOVE REAR SEAT HEADREST ASSEMBLY LH
13. REMOVE REAR SEAT INNER TRACK BRACKET COVER LH
14. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH
15. DISCONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY
16. REMOVE REAR SEAT ASSEMBLY LH
17. REMOVE RECLINING REMOTE CONTROL BEZEL LH
18. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY LH
19. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
21. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH
22. REMOVE POWER BACK DOOR ROD
(a) Using a screwdriver, remove the stop ring along the groove. HINT: Tape the screwdriver tip before use. Text in Illustration
|
|
(b) Release the ball joint and disengage the power back door rod.
(c) Using a screwdriver, remove the stop ring along the groove. HINT: Tape the screwdriver tip before use. Text in Illustration
|
|
(d) Release the ball joint and remove the power back door rod.
23. REMOVE POWER BACK DOOR UNIT ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 4 bolts and power back door unit assembly.
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
Vehicles with smart key system:
Turn the “ENGINE START STOP” switch off.
Vehicles without smart key system:
Turn th ...
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION OF SYSTEM
(a) Each tire pressure warning valve and transmitter is equipped with a tire
pressure sensor and a transmitter and is installed in each tire and wheel assembly.
The sensor measures the tire pressure. The measur ...
All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate
DESCRIPTION
When the entry door lock and unlock functions and wireless door lock and unlock
functions do not operate, radio wave interference, or a malfunction in the key or
signal circuit between the door control receiver assembly and certification ECU
...