REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL LH
2. REMOVE FRONT FENDER OUTSIDE MOULDING LH
3. REMOVE FRONT FENDER LINER LH
(a) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips. Text in Illustration
|
|
(b) Remove the 5 clips <A>. Text in Illustration
|
|
(c) Remove the clip <B>.
(d) Remove the bolt and 6 screws. |
|
(e) Remove the grommet and front fender liner LH.
HINT:
The grommets need to be replaced with new ones because they will break when they are removed.
4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE RADIATOR GRILLE
6. REMOVE LOW PITCHED HORN ASSEMBLY
7. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
(a) Using a screwdriver, remove the hood lock nut cap. Text in Illustration
HINT: Tape the screwdriver tip before use. |
|
(b) Remove the 3 bolts. |
|
(c) Disconnect the hood lock control cable and remove the hood lock assembly. |
|
8. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
(a) Using a screwdriver, remove the hood lock nut cap. Text in Illustration
HINT: Tape the screwdriver tip before use. |
|
(b) Disconnect the connector. |
|
(c) Remove the 3 bolts.
(d) Disconnect the hood lock control cable and remove the hood lock assembly. |
|
9. REMOVE FRONT DOOR SCUFF PLATE LH
10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Using a screwdriver, disconnect each clamp shown in the illustration.
Text in Illustration
*1 |
Hood Lock Control Cable |
*3 |
Hood Cable Grommet |
*2 |
Clamp |
- |
- |
HINT:
Tape the screwdriver tip before use.
(b) Pull the hood lock control cable assembly from the engine compartment and remove it.
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(See page )
2. REMOVE NO. 1 ANTENNA CORD SUB-ASSEMBLY
(a) Disengage the 7 clamps and remove the No. 1 antenna cord sub-assembly.
3. REMOVE ROOF HEADLINING ASSEMBLY
(See page )
4. REMO ...
Clearance Warning ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the clearance warning ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDUR ...
Registered Device cannot be Deleted
PROCEDURE
1.
DELETE OPERATION
(a) Check if a registered portable player can be deleted normally.
OK:
Registered portable player can be deleted normally.
OK
END
NG
PROCEED TO ...