Toyota Venza: Removal

Toyota Venza Service Manual / Rear Suspension / Rear Stabilizer Bar(for Awd) / Removal

REMOVAL

PROCEDURE

1. REMOVE REAR WHEELS

2. REMOVE REAR STABILIZER LINK ASSEMBLY LH

(a) Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.

Text in Illustration

*1	Turn
*2	Hold

HINT:

If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.

(b) Remove the nut and the rear stabilizer link assembly LH from the rear shock absorber with coil spring LH.

Text in Illustration

*1	Turn
*2	Hold

HINT:

If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.

3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as the LH side.

4. REMOVE NO. 1 FLOOR UNDER COVER

5. REMOVE REAR LOWER SUSPENSION BRACE (for LH Side)

(a) Remove the bolt, the nut and the rear lower suspension brace (LH side).

6. REMOVE REAR LOWER SUSPENSION BRACE (for RH Side)

HINT:

Perform the same procedure as the LH side.

7. REMOVE REAR STABILIZER BAR BRACKET LH (for Rear Side)

(a) Remove the 2 bolts and the rear stabilizer bar bracket LH (rear side).

8. REMOVE REAR STABILIZER BAR BRACKET RH (for Rear Side)

(a) Remove the 2 bolts and the rear stabilizer bar bracket RH (rear side).

9. REMOVE REAR STABILIZER BUSHING (for LH Side)

(a) Remove the rear stabilizer bushing (LH side).

10. REMOVE REAR STABILIZER BUSHING (for RH Side)

(a) Remove the rear stabilizer bushing (RH side).

11. REMOVE REAR STABILIZER BAR BRACKET LH (for Front Side)

(a) Remove the bolt and the rear stabilizer bar bracket LH (front side).

12. REMOVE REAR STABILIZER BAR BRACKET RH (for Front Side)

(a) Remove the 2 bolts and the rear stabilizer bar bracket RH (front side).

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR STABILIZER LINK ASSEMBLY (a) Move the ball joint stud back and forth 5 times before installing the nut as shown in the illustration. ...

Installation

INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL REAR STABILIZER BAR BRACKET LH (for Front Side) (a) Temporarily install the rear stabilizer bar bracket LH (front side) with the bolt. ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (a) Check that the ignition switch is off. ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedures to troubleshoot the tire pressure warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (See page ) 2. REMOVE ULTRASONIC SENSOR CLIP (a) Disconnect the connector. Text in Illustration *A LH Side *B ...