Toyota Venza: Removal

Toyota Venza Service Manual / Front Suspension / Front Lower Suspension Arm(when Not Using The Engine Support Bridge) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.

PROCEDURE

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 2GR-FE)

HINT:

Refer to the procedure up to Remove Engine Assembly with Transaxle (See page ).

2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 1AR-FE)

HINT:

Refer to the procedure up to Remove Engine Assembly with Transaxle (See page ).

3. REMOVE FRONT NO. 1 STABILIZER BRACKET LH (for AWD)

4. REMOVE FRONT NO. 1 STABILIZER BRACKET RH (for AWD)

HINT:

Perform the same procedure as for the LH side.

5. REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY (for AWD)

6. REMOVE STEERING LINK ASSEMBLY (for AWD)

7. REMOVE FRONT FRAME ASSEMBLY (for 2GR-FE)

8. SEPARATE REAR ENGINE MOUNTING INSULATOR ASSEMBLY (for 1AR-FE AWD)

9. REMOVE FRONT FRAME ASSEMBLY (for 1AR-FE)

10. REMOVE ENGINE MOUNTING INSULATOR LH (for 2GR-FE)

11. REMOVE ENGINE MOUNTING INSULATOR LH (for 1AR-FE)

12. REMOVE FRONT LOWER SUSPENSION ARM

(a) Remove the 3 bolts, nut and front lower suspension arm from the front frame assembly.

(b) Remove the front lower arm bushing stopper from the front lower suspension arm.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT LOWER SUSPE ...

Other materials about Toyota Venza:

System Description
SYSTEM DESCRIPTION 1. POWER MIRROR CONTROL SYSTEM DESCRIPTION (a) This system has the following functions: power retract mirror function*, reverse shift-linked function, electrical remote control function, memory function and mirror heater function. ...

Starter Signal Circuit
DESCRIPTION 1. w/o Smart Key System While the engine is being cranked, current flows from terminal ST1 of the ignition switch assembly to the park/neutral position switch assembly and also flows to terminal STA of the ECM (STA Signal). 2. w/ Smart Key S ...

Turn signal lever
1. Right turn 2. Left turn 3. Move and hold the lever partway to signal a lane change. The right hand signal will flash until you release the lever. 4. Move and hold the lever partway to signal a lane change. The left hand signal will flash until you re ...