REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.
PROCEDURE
1. INSTALL ENGINE ON ENGINE STAND
(See page )
2. REMOVE IGNITION COIL ASSEMBLY
3. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
4. REMOVE CRANKSHAFT POSITION SENSOR
5. REMOVE CRANKSHAFT PULLEY
6. REMOVE ENGINE MOUNTING BRACKET RH
(a) Remove the 5 bolts and engine mounting bracket RH. |
|
7. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
8. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
(a) Remove the 17 bolts and 2 nuts. |
|
(b) Remove the timing chain cover sub-assembly by prying between the timing chain cover sub-assembly and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase and timing chain cover sub-assembly.
HINT:
Tape the screwdriver tip before use.
(c) Remove the 2 oil pump gaskets and oil hole cover gasket from the stiffening crankcase. |
|
9. REMOVE TIMING CHAIN COVER OIL SEAL
(a) Using a screwdriver and wooden block, pry out the timing chain cover oil seal. NOTICE: Do not damage the surface of the timing chain cover oil seal press fit hole. HINT: Tape the screwdriver tip before use. |
|
Vanity Light
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL VANITY LIGHT ASSEMBLY
(a) Engage the 3 claws and install the vanity light assembly.
2. INSTALL ROOF HEADLI ...
Hill-start assist control
Hill-start assist control helps to prevent the vehicle from rolling backwards
when starting on incline or slippery slope.
To engage hill-start assist control, further depress the brake pedal when the
vehicle is stopped completely.
A buzzer will sound o ...
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Communication Method
Center airbag sensor assembly
Combination meter assembly
Front seat inner belt buckl ...