Toyota Venza: Removal

Toyota Venza Service Manual / 1ar-fe Intake / Exhaust / Exhaust Pipe / Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves when removing the exhaust pipe.

The exhaust pipe is extremely hot immediately after the engine has stopped.

Confirm that the exhaust pipe has cooled down before removing it.

PROCEDURE

1. REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY

(a) Using a plastic hammer, uniformly tap off the tail exhaust pipe baffle sub-assembly.

2. REMOVE TAIL EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts and 2 compression springs.

(b) Disconnect the tail exhaust pipe assembly from the 4 exhaust pipe supports.

3. REMOVE CENTER EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts.

(b) Disconnect the center exhaust pipe assembly from the 2 exhaust pipe supports.

4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Disconnect the heated oxygen sensor connector.

(b) Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly from the exhaust manifold converter sub-assembly.

5. REMOVE HEATED OXYGEN SENSOR

Installation

INSTALLATION PROCEDURE 1. INSTALL HEATED OXYGEN SENSOR 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Using a vernier caliper, measure the free length of the compression springs. ...

Intake Air Control Valve Actuator(for Tcv)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD (a) Remove the intake manifold (See page ). 2. REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) ...

Other materials about Toyota Venza:

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Stereo Component Amplifier Disconnected (B15D3)
DESCRIPTION The navigation receiver assembly and stereo component amplifier assembly are connected via AVC-LAN communication. This DTC is stored when an AVC-LAN communication error occurs between the navigation receiver assembly and stereo component ampl ...

Removal
REMOVAL PROCEDURE 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) 3. REMOVE NO. 2 CONSOLE BOX CARPET 4. REMOVE CONSOLE BOX ASSEMBLY 5. REMOVE AIR CONDITION ...