Toyota Venza: Removal

Toyota Venza Service Manual / 1ar-fe Fuel / Fuel Injector / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repair" after replacing the fuel injector assembly (See page ).

PROCEDURE

1. DISCHARGE FUEL SYSTEM PRESSURE

(a) Discharge fuel system pressure (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Remove the windshield wiper motor and link assembly (See page ).

4. REMOVE OUTER COWL TOP PANEL

5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

6. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

8. DISCONNECT FUEL TUBE SUB-ASSEMBLY

(a) Remove the No. 1 fuel pipe clamp.

(b) Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.

Text in Illustration

*1	Fuel Pipe
*2	Fuel Tube Connector
*3	Nylon Tube
*4	O-ring
*5	Retainer
	Pinch
	Pull

NOTICE:

Check for foreign matter on the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.
Do not use any tools to separate the fuel tube connector and fuel pipe.
Do not forcibly bend, kink or twist the nylon tube.
Keep the connector and pipe free from foreign matter.
If the fuel tube connector and fuel pipe are stuck, push and pull to release them.
Cover the fuel tube connector and fuel pipe with plastic bags to prevent damage and contamination.

9. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

10. DISCONNECT WIRE HARNESS

(a) Disconnect the 4 fuel injector connectors.

(b) Disconnect the 2 connectors.

(d) Disengage the clamp to disconnect the wire harness.

11. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

(a) Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injectors.

NOTICE:

Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

(b) Remove the 2 fuel delivery spacers from the cylinder head.

12. REMOVE FUEL INJECTOR ASSEMBLY

(a) Pull the 4 fuel injectors out of the fuel delivery pipe.

(b) Remove the O-ring from each fuel injector.

NOTICE:

Prevent entry of foreign matter by covering the fuel injectors with plastic bags.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connec ...

Other materials about Toyota Venza:

No Sound can be Heard from Speakers
PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio system returns to normal. HINT: Sound quality adjustment mea ...

System Description
SYSTEM DESCRIPTION 1. GENERAL This system has the following functions: manual slide open and close; auto slide open; manual tilt up and down; auto tilt up; jam protection; key off operation. 2. FUNCTION OF MAIN COMPONENT Component O ...

Random Access Memory (RAM) (P0604)
MONITOR DESCRIPTION The ECM continuously monitors its internal memory status. This self-check ensures that the ECM is functioning properly. It is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) ...