REMOVAL
PROCEDURE
1. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(a) Remove the windshield wiper motor and link (See page ).
2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE NO. 1 ENGINE UNDER COVER
6. REMOVE NO. 2 ENGINE UNDER COVER
7. DRAIN ENGINE COOLANT
8. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
(a) Disconnect the mass air flow meter connector and separate the wire harness clamp from the air cleaner cap. |
|
(b) Separate the hose from the hose clamp.
(c) Disconnect the ventilation hose from the cylinder head cover. |
|
(d) Unlock the hose band and separate the air cleaner cap sub-assembly from the throttle body assembly. |
|
(e) Remove the 2 bolts and air cleaner cap sub-assembly. |
|
10. REMOVE THROTTLE BODY ASSEMBLY
(a) Disconnect the throttle body assembly connector. |
|
(b) Disconnect the fuel tube from the clamp.
(c) Disconnect the 2 water by-pass hoses from the throttle body assembly. |
|
(d) Remove the 4 bolts and the throttle body assembly with the fuel tube bracket. |
|
(e) Remove the bolt and fuel tube bracket. |
|
(f) Remove the gasket from the intake manifold. |
|
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT SEAT WIRE RH (for Front Passenger Side)
(a) Engage each clamp and install the front seat wire RH.
2. INSTALL OCCUPANT CLASSIFICATION ECU (for Front Passenger Side)
3. INSTALL SEAT POSITION SENSOR
4. INSTALL SEA ...
Pressure Sensor Circuit (B1423/23)
DESCRIPTION
This DTC is output when refrigerant pressure on the high pressure side is extremely
low (190 kPa (1.9 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2,
455 psi) or more). The A/C pressure sensor is installed on the high pres ...
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Communication Method
Main Body ECU (Driver Side Junction Block Assembly)
Combination Meter Assembly
Driver side door ...