Toyota Venza: Relay

Toyota Venza Service Manual / Brake Control / Dynamic Control Systems / Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE STOP LIGHT CONTROL (BRK) RELAY

(a) Remove the stop light control (BRK) relay.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 4	Voltage is not applied between terminals 1 and 2	Below 1 Ω
3 - 5	Voltage is not applied between terminals 1 and 2	10 kΩ or higher
3 - 4	Voltage is applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Voltage is applied between terminals 1 and 2	Below 1 Ω

Text in Illustration

*1	Stop Light Control (BRK) Relay

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. If the sensor rotor needs to be replaced, repla ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. EXPRESSIONS OF IGNITION SWITCH The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Switc ...

Horn
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LOW PITCHED HORN ASSEMBLY (a) Apply battery voltage and check the operation of the low pitched horn assembly according to the table below. OK: ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE RECLINING POWER SEAT SWITCH KNOB 6. REMOVE SLIDE AND VER ...

Toyota Venza: Relay

Removal

Steering Angle Sensor

Other materials about Toyota Venza: