On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT TAILLIGHT RELAY (TAIL)
(a) Remove the taillight relay from the main body ECU (driver side junction block assembly). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 - 5 |
Battery voltage applied to terminals 1 and 2 |
Below 1 Ω |
Battery voltage not applied between terminals |
10 kΩ or higher |
|
3 - 4 |
Battery voltage applied to terminals 1 and 2 |
10 kΩ or higher |
Battery voltage not applied between terminals |
Below 1 Ω |
If the result is not as specified, replace the taillight relay.
2. INSPECT FOG LIGHT RELAY (FOG)
(a) Remove the fog light relay from the main body ECU (driver side junction block assembly). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 - 5 |
Battery voltage applied to terminals 1 and 2 |
Below 1 Ω |
3 - 5 |
Battery voltage not applied between terminals |
10 kΩ or higher |
If the result is not as specified, replace the fog light relay.
3. INSPECT BI-XENON RELAY
(a) Remove the BI-XENON relay from the power distributor (engine room junction block assembly). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 - 5 |
Battery voltage applied to terminals 1 and 2 |
Below 1 Ω |
3 - 5 |
Battery voltage not applied between terminals |
10 kΩ or higher |
If the result is not as specified, replace the BI-XENON relay.
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the steering
pad.
PROCEDURE
1. INSPECT STEERING PAD (Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (S ...
System Description
SYSTEM DESCRIPTION
1. GENERAL
(a) Deceleration sensors used for the airbag system are installed on various
parts on the vehicle and calculate the deceleration rate of each part during a collision.
(b) Depending on the situation, the center airbag sensor a ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)
2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)
4. ...