• Regulations regarding the use of tire chains vary according to location and type of road. Always check local regulations before installing chains.
• Retighten the chains after driving 1/4 - 1/2 mile (0.5 - 1.0 km).
- Tire chains
Observe the following precautions when installing and removing chains.
• Install and remove tire chains in a safe location.
• Install tire chains on the front tires only. Do not install tire chains on the rear tires.
• Install tire chains following the instructions provided in the accompanying manual.
CAUTION
- Driving with snow tires
Observe the following precautions to reduce the risk of accidents.
Failing to do so may result in a loss of vehicle control and cause death or serious injury.
• Use tires of the size specified for your vehicle.
• Maintain the recommended level of tire inflation pressure.
• Do not drive in excess of 75 mph (120 km/h), regardless of the type of snow tires being used.
• Snow tires should be installed on all wheels.
- Driving with tire chains
Observe the following precautions to reduce the risk of accidents.
Failing to do so may result in the vehicle being unable to be driven safely, and may cause death or serious injury.
• Do not drive in excess of the speed limit specified for the tire chains being used, or 30 mph (50 km/h), whichever is lower.
• Avoid driving on bumpy road surfaces or over potholes.
• Avoid sudden acceleration, abrupt steering, sudden braking and shifting operations that cause sudden engine braking.
• Slow down sufficiently before entering a curve to ensure that vehicle control is maintained.
NOTICE
- Repairing or replacing snow tires
Request repairs of and obtain replacement snow tires from Toyota dealers or legitimate tire retailers.
This is because the removal and attachment of snow tires affects the operation of the tire pressure warning valves and transmitters.
- Fitting tire chains
The tire pressure warning valves and transmitters may not function correctly when tire chains are fitted.
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (When Using the Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream. Enter ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (When Using Techstream)
(a) Check the DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream screen. Enter the ...
Fail-safe Chart
FAIL-SAFE CHART
1. FAIL-SAFE OPERATION
If there is a problem with sensor signals or actuator systems, the skid
control ECU prohibits power supply to the brake actuator assembly and informs
the ECM of VSC system malfunction.
The brake actuat ...