Toyota Venza: Receiver Error (C2176/76)

Toyota Venza Service Manual / Tire Pressure Monitoring / Tire Pressure Warning System / Receiver Error (C2176/76)

DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC No.	DTC Detection Condition	Trouble Area
C2176/76	Malfunction in the tire pressure warning ECU internal circuit	Tire pressure warning ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform registration (See page ) of the transmitter IDs into the tire
pressure warning ECU if the ECU has been replaced.

PROCEDURE

1.	CHECK DTC OUTPUT (C2176/76)

(a) Clear the DTC (See page ).

(b) Turn the ignition switch off.

OK:

DTC C2176/76 is not output.

END

REPLACE TIRE PRESSURE WARNING ECU

Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)

DESCRIPTION The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to d ...

Transmitter ID not Registered (C2171/71)

DESCRIPTION Each tire pressure warning valve and transmitter ID is registered to the tire pressure warning ECU. When the ECU detects a transmitter ID code not registered in the ECU, a DTC is out ...

Other materials about Toyota Venza:

Engine Coolant Temperature Receiver Gauge Malfunction
DESCRIPTION In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN No. 1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from th ...

Unlock Warning Switch Circuit
DESCRIPTION The key unlock warning switch assembly turns on when the ignition key is inserted into the ignition key cylinder and turns off when the ignition key is removed. The main body ECU (driver side junction block assembly) operates the key confinemen ...

Trip information
Display items can be switched by pressing the “INFO” button. - Average Fuel Economy Displays the average fuel consumption since the function was reset. • The function can be reset by pressing and holding the “SELECT RESET” button when the ...