Toyota Venza: Reassembly

Toyota Venza Service Manual / U660e Automatic Transmission / Transaxle / Shift Lever / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL SHIFT LOCK CONTROL COMPUTER SUB-ASSEMBLY

(a) Engage the 3 claws to install the shift lock control computer sub-assembly.

(b) Connect the connector.

2. INSTALL LOWER POSITION INDICATOR HOUSING

(a) Put the guide in position and engage the 2 claws to install the lower position indicator housing to the shift lock control unit assembly.

NOTICE:

Make sure that the claws are firmly engaged.

3. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER

(a) Install the No. 2 position indicator slide cover to the position indicator slide cover.

4. INSTALL POSITION INDICATOR SLIDE COVER

(a) Install the position indicator slide cover to the lower position indicator housing as shown in the illustration.

5. INSTALL UPPER POSITION INDICATOR HOUSING

(a) Engage the 4 claws to install the upper position indicator housing to the lower position indicator housing.

NOTICE:

Make sure that the claws are firmly engaged.

6. INSTALL POSITION INDICATOR LIGHT BULB

(a) Install the position indicator light bulb to the indicator light wire sub-assembly.

(b) Install the position indicator light cap to the position indicator light bulb.

7. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY

(a) Install the indicator light wire socket and connector to the position indicator light guide.

8. INSTALL SHIFT LOCK RELEASE BUTTON

(a) Engage the 2 claws to install the shift lock release button and compression spring to the lower position indicator housing.

NOTICE:

Make sure that the claws are firmly engaged.

9. INSTALL POSITION INDICATOR LIGHT GUIDE

(a) Engage the 4 claws to install the position indicator connector and position indicator light guide to the lower position indicator housing.

NOTICE:

Make sure that the claws are firmly engaged.

10. INSTALL POSITION INDICATOR HOUSING SUB-ASSEMBLY

(a) Engage the 4 claws to install the position indicator housing sub-assembly to the lower position indicator housing.

NOTICE:

Make sure that the claws are firmly engaged.

(b) Install the shift lever cap to the position indicator housing sub-assembly.

Installation

INSTALLATION PROCEDURE 1. INSTALL SHIFT LEVER ASSEMBLY NOTICE: Check that the park/neutral position switch and the shift lever are in neutral. (a) Slide the slider of the transmission ...

Speed Sensor(when Not Using The Engine Support Bridge)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY HINT: See the steps from "Remove Engine Assembly with transaxle" through &qu ...

Other materials about Toyota Venza:

Repair
REPAIR PROCEDURE 1. REPAIR INTAKE VALVE SEAT NOTICE: Repair the seat while checking the seating position. Keep the lip free of foreign matter. Take off the cutter gradually to make the intake valve seat smooth. (a) Usin ...

Front Passenger Side Door Entry Unlock Function does not Operate
DESCRIPTION If the front passenger door entry lock function operates normally, but its entry unlock function does not, this means that the request code from the front passenger door is being output normally. In this case, a malfunction in the touch sensor ...

Front Sensor Communication Malfunction (C1AEC)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor. DTC No. DTC Detection Condition Trou ...