Toyota Venza: Reassembly

Toyota Venza Service Manual / Brake System (other) / Brake Pedal / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL STOP LIGHT SWITCH CUSHION

(a) Install the stop light switch cushion to the brake pedal support assembly.

2. INSTALL BRAKE PEDAL PAD

(a) Install the brake pedal pad to the brake pedal support assembly.

3. INSTALL BRAKE PEDAL RETURN SPRING

(a) Install the brake pedal return spring to the brake pedal support assembly.

Adjustment

ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Check the brake pedal height. (1) Turn back the carpet. (2) Measure the brake pedal height from the dash panel to the ...

Installation

INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt. Torque: 19 N· ...

Other materials about Toyota Venza:

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Back Door Closer System ...

Short in Front Passenger Side Squib 2nd Step Circuit (B1815/54-B1818/54)
DESCRIPTION The front passenger side squib 2nd step circuit consists of the center airbag sensor assembly and front passenger airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. T ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System DTC Code Detection Item See page B1532 LVDS Signal Malfunction (from Extension Module) B1551 HD Radio ...