REASSEMBLY
PROCEDURE
1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY
(a) Install the front blower motor sub-assembly with the 3 screws. |
|
2. INSTALL AIR INLET SERVO MOTOR SUB-ASSEMBLY
(a) Install the air inlet servo motor sub-assembly with the 3 screws. |
|
(b) Engage the 6 claws. |
|
(c) install the blower case with the screw.
3. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) Install the air conditioning amplifier assembly with the 2 screws. |
|
4. INSTALL CLEAN AIR FILTER
(a) Install the clean air filter as shown in the illustration. |
|
5. INSTALL AIR FILTER COVER PLATE
(a) Engage the 2 claws to install the air filter cover plate. |
|
6. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY
(a) Engage the 4 claws to install the No. 1 air duct sub-assembly. |
|
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Removal
REMOVAL
PROCEDURE
1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
3. REMOVE FRONT WHEE ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL PUMP ASSEMBLY WITH FILTER
(a) Inspect fuel pump resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
...