REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and install the No. 1 sunshade trim sub-assembly. |
|
2. INSTALL NO. 2 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and install the No. 2 sunshade trim sub-assembly. |
|
3. INSTALL NO. 3 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and install the No. 3 sunshade trim sub-assembly. |
|
4. INSTALL NO. 4 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and install the No. 4 sunshade trim sub-assembly. |
|
(b) Install the front sliding roof sunshade stopper LH with the screw. HINT: Use the same procedure for the RH side and the LH side. |
|
(c) Install the center sliding roof sunshade stopper LH with the screw. HINT: Use the same procedure for the RH side and the LH side. |
|
(d) Install the rear sliding roof sunshade stopper LH with the screw. HINT: Use the same procedure for the RH side and the LH side. |
|
5. INSTALL SLIDING ROOF HOUSING CENTER FRAME
(a) Install the sliding roof housing center frame with the 2 nuts. Torque: 7.0 N·m {71 kgf·cm, 62 in·lbf} |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the camshaft, No. 2 camshaft,
camshaft timing gear assembly, camshaft timing exhaust gear assembly or cylinder
head sub-assembly (See page ).
PROCED ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WIPER ARM HEAD CAP
(a) Using a screwdriver, remove the 2 front wiper arm head caps as shown
in the illustration.
Text in Illustration
*1
Protective Tape
...
Fail-safe Chart
FAIL-SAFE CHART
1. FAIL-SAFE OPERATION
If there is a problem with sensor signals or actuator systems, the skid
control ECU prohibits power supply to the brake actuator assembly and informs
the ECM of VSC system malfunction.
The brake actuat ...