REASSEMBLY
PROCEDURE
1. INSTALL FRONT BUMPER SIDE RETAINER LH
(a) Engage the claw and install the front bumper side retainer LH. Text in Illustration
|
|
(b) Install the bolt and screw.
Torque:
Bolt :
3.6 N·m {37 kgf·cm, 32 in·lbf}
2. INSTALL FRONT BUMPER SIDE RETAINER RH
HINT:
Use the same procedure for the RH side and LH side.
3. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
(a) Install the front bumper reinforcement sub-assembly with the 6 bolts. Torque: 34 N·m {347 kgf·cm, 25 ft·lbf} |
|
(b) Engage the 4 clamps.
4. INSTALL FRONT BUMPER ENERGY ABSORBER
(a) Engage the 2 guides to install the front bumper energy absorber. |
|
5. INSTALL FRONT FENDER LINER RETAINER
(a) Install the 2 front fender liner retainers. HINT: Use the same procedure for the RH side and LH side. |
|
6. INSTALL FRONT BUMPER MOULDING
(a) Engage the 5 claws. |
|
(b) Install the front bumper moulding with the 2 screws.
7. INSTALL NO. 1 LOWER RADIATOR GRILLE
(a) Engage the 14 claws to install the No. 1 lower radiator grille. |
|
8. INSTALL FRONT BUMPER HOLE COVER ASSEMBLY LH
(a) Engage the 4 claws and pin, and install the front bumper hole cover assembly LH. |
|
9. INSTALL FRONT BUMPER HOLE COVER ASSEMBLY RH
HINT:
Use the same procedure for the RH side and LH side.
10. INSTALL FOG LIGHT ASSEMBLY LH
11. INSTALL FOG LIGHT ASSEMBLY RH
HINT:
Use the same procedure for the RH side and LH side.
12. INSTALL FRONT LICENSE PLATE BRACKET
(a) Install the front license plate bracket with the 2 screws. |
|
13. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)
14. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
Driver Side Power Window Auto Up / Down Function does not Operate with Power
Window Master Switch
DESCRIPTION
If the manual up/down function can be performed but the auto up/down function
cannot, then the fail-safe mode may be functioning.
If the power window initialization (See page
) has not been performed, the auto up/down function
will not oper ...
Theft Deterrent System Presence Detection (B279C)
DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed,
the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
B279C
An ECM that is incompatible ...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS component, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous mate ...