Toyota Venza: Reassembly

Toyota Venza Service Manual / Steering Gear / Linkage / Steering Gear(when Using The Engine Support Bridge For Awd) / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL NO. 2 STEERING RACK BOOT

(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.

(b) Install the No. 2 steering rack boot to the groove on the rack housing.

NOTICE:

Be careful not to damage or twist the boot.
Make sure that the boot is free of rust and foreign matter.

2. INSTALL NO. 1 STEERING RACK BOOT

HINT:

Perform the same procedure as for the No. 2 steering rack boot.

3. INSTALL NO. 2 STEERING RACK BOOT CLAMP

(a) Using SST, tighten a new No. 2 steering rack boot clamp as shown in the illustration.

SST: 09521-24010

Clearance:

3.0 mm (0.118 in.) or less

NOTICE:

Be careful not to damage or twist the boot.

4. INSTALL NO. 1 STEERING RACK BOOT CLAMP

HINT:

Perform the same procedure as for the No. 2 steering rack boot clamp.

SST: 09521-24010

5. INSTALL STEERING RACK BOOT CLIP (for LH Side)

(a) Using pliers, install the steering rack boot clip.

6. INSTALL STEERING RACK BOOT CLIP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

7. INSPECT STEERING GEAR ASSEMBLY

(a) Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.

SST: 09616-00020

HINT:

If the operation cannot be done as specified, use new steering rack boot clamps and reinstall the steering rack boots.

Inspection

INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH (a) Secure the tie rod assembly LH in a vise. (b) Install the nut to the stud bolt. ( ...

Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. ...

Other materials about Toyota Venza:

Transfer System
Precaution PRECAUTION Prior to starting any work, clean the transfer assembly to prevent sand or mud deposits from entering the assembly. When removing any light alloy components such as the transfer cover, do not pry on the component wi ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP (a) Remove the rear part of the rear door opening trim weatherstrip to the extent that allows removal of the deck trim side panel assembly ...

Lost Communication with Gateway Module (Power Management2) (U1002)
DESCRIPTION The power management control ECU will store this DTC when no signals can be received from the ECUs that have been memorized as those that are connected to the power management bus. When the power management control ECU receives ...