REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use high-temperature grease to lubricate the bearings, gears and return spring when assembling the starter.
PROCEDURE
1. INSTALL PLANETARY GEAR
(a) Apply grease to the planetary gears and pin parts of the planetary shaft. |
|
(b) Install the 3 planetary gears.
2. INSTALL STARTER ARMATURE ASSEMBLY
(a) Apply grease to the plate washer and the armature shaft.
NOTICE:
(b) Install the starter armature to the starter commutator end frame.
(c) Using snap ring pliers, install the plate washer and a new snap ring. Text in Illustration
|
|
(d) Using a vernier caliper, measure the length of the snap ring. Text in Illustration
Maximum length: 5.0 mm (0.196 in.) If the length is greater than the maximum, replace it with a new snap ring. |
|
3. INSTALL STARTER COMMUTATOR END FRAME COVER
(a) Install the end frame cover to the commutator end frame. |
|
4. INSTALL STARTER ARMATURE PLATE
(a) Insert the starter armature plate to the starter yoke. Text in Illustration
|
|
(b) Align the keyway of the starter armature plate with the key inside the starter yoke, and install the starter armature plate.
5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
(a) Align the rubber of the end frame with the cutout of the starter yoke. Text in Illustration
|
|
(b) Install the end frame to the starter yoke.
NOTICE:
The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.
6. INSTALL STARTER YOKE ASSEMBLY
(a) Align the protrusion of the starter yoke with the cutout of the starter drive housing. Text in Illustration
|
|
(b) Install the starter yoke with the 2 through-bolts. Torque: 6.0 N·m {61 kgf·cm, 53 in·lbf} |
|
7. INSTALL MAGNETIC SWITCH ASSEMBLY
(a) Apply grease to the plunger and the hook. |
|
(b) Hang the plunger hook of the magnetic switch to the drive lever.
(c) Install the plunger and return spring.
(d) Install the magnetic switch with the 2 screws. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} |
|
(e) Connect the lead wire to the magnetic switch with the nut. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} |
|
Drive Belt
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT V-RIBBED BELT
(a) Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-r ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL STIFFENING CRANKCASE RING PIN
NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.
(a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop.
Text in Illustration
...
Torque Sensor Zero Point Adjustment Incomplete (C1516,C1526)
DESCRIPTION
These DTCs do not indicate a malfunction. The power steering ECU stores these
DTCs when it determines that the rotation angle sensor value initialization and
torque sensor zero point calibration are incomplete.
DTC No.
D ...