REASSEMBLY
PROCEDURE
1. INSTALL FUEL PUMP ASSEMBLY WITH FILTER
HINT:
Perform "Inspection After Repair" after replacing the fuel pump (See page ).
(a) Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump. Text in Illustration
|
|
(b) Engage the 5 claws on the fuel filter and install the fuel pump assembly with filter. NOTICE:
|
|
2. INSTALL FUEL FILTER ASSEMBLY
(a) Apply gasoline to a new O-ring and install it to the jet pump. Text in Illustration
|
|
(b) Install the jet pump to the sub-tank as shown in the illustration. |
|
(c) Connect the jet pump nozzle to the fuel sub-tank. |
|
(d) Install the fuel filter to the sub-tank and attach the 2 claws. |
|
(e) Connect the fuel pump connector to the fuel pump. |
|
3. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
(a) Install the spring to the fuel suction plate shaft.
(b) Install the fuel suction plate to the sub-tank.
(c) Install a new E-ring. Text in Illustration
|
|
(d) Connect the fuel pump connector to the fuel suction plate. |
|
4. INSTALL FUEL SENDER GAUGE
Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced.
Otherwise, the tire may separate from the wheel or cause loss of handling control.
- Wheel selection
When replacing wheels, care should be taken to ensure that they are equivalent ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BREATHER PLUG HOSE
(a) Using a screwdriver, remove the No. 2 breather plug (ATM) from the
transaxle case sub-assembly.
(b) Using a screwdriver, remove ...
Voice is not Recognized
PROCEDURE
1.
CHECK CONDITION
(a) Check if the system voice recognition level is low when recognizing a particular
voice.
Result
Proceed to
System voice recognition level is low only fo ...