Toyota Venza: Rear window wiper and washer
Type A
1. 
Off
2. 
Intermittent window wiper operation
3. 
Normal window wiper operation
4. 
Washer/wiper dual operation
5. 
Washer/wiper dual operation
Type B
1. 
Off
2. 
Intermittent window wiper operation
3. 
Normal window wiper operation
4. 
Washer/wiper dual operation
5. 
Washer/wiper dual operation
- The rear window wiper and washer can be operated when
► Vehicles with smart key system The “ENGINE START STOP” switch is in IGNITION ON mode.
► Vehicles without smart key system The engine switch is in the “ON” position.
NOTICE
- When the rear window is dry
Do not use the wipers, as they may damage the rear window.
Fog light switch
The fog lights improve visibility in difficult driving conditions, such as
in rain or fog. The fog lights can be used when the headlights are on low beam.
Type A
1. Off
2. On
Type B
1. O ...
Other materials about Toyota Venza:
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE MAGNETIC SWITCH ASSEMBLY
(a) Remove the nut and disconnect the lead wire from the magnetic switch.
(b) Remove the 2 screws holding the magnetic switch to t ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL DRIVE MONITOR SWITCH
(a) Engage the 4 claws to install the drive monitor switch.
2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display
Type)
3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH B ...
Front Occupant Classification Sensor LH Circuit Malfunction (B1780)
DESCRIPTION
The front occupant classification sensor LH circuit consists of the occupant
classification ECU and front occupant classification sensor LH.
DTC B1780 is recorded when a malfunction is detected in the front occupant classification
sensor LH c ...
0.1714