Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER BACK WINDOW PANEL TRIM
2. REMOVE REAR SPOILER ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 2 hole plugs.
(c) Remove the 4 bolts.
(d) Disengage the 3 pins to remove the rear spoiler assembly. |
|
3. REMOVE CENTER STOP LIGHT ASSEMBLY
(a) Remove the 2 screws and center stop light assembly. |
|
4. REMOVE CENTER STOP LIGHT CORD ASSEMBLY
(a) Disconnect the connector and remove the center stop light cord assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL CENTER STOP LIGHT CORD ASSEMBLY
(a) Connect the connector and install the center stop light cord assembly. |
|
2. INSTALL CENTER STOP LIGHT ASSEMBLY
(a) Install the center stop light assembly with the 2 screws to the rear spoiler assembly. |
|
3. INSTALL REAR SPOILER ASSEMBLY
(a) Engage the 3 pins to install the rear spoiler assembly. |
|
(b) Install the 4 bolts. |
|
(c) Install the 2 hole plugs.
(d) Connect the connector.
4. INSTALL UPPER BACK WINDOW PANEL TRIM
Installation
INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the generator with the 2 bolts.
Torque:
52 N·m {530 kgf·cm, 38 ft·lbf}
(b) Install the wire harness clamp bracke ...
Follow the correction procedures. (smart key system)
After taking the specified steps to correct the suspected problem, check that
the warning light turns off.
- If the malfunction indicator lamp comes on while driving
First check the following:
• Is the fuel empty?
If it is, fill the fuel tan ...
Power Source Mode does not Change to ON (IG)
DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power
management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Techstream to inspect the push-button start function when
the ...