Toyota Venza: Rear Shock Absorber

Removal

REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See p ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Torque Sensor Circuit Malfunction (C1511-C1514,C1517)
DESCRIPTION The torque sensor converts the rotation torque input to the steering wheel into an electrical signal and sends it to the power steering ECU. Based on this signal, the ECU detects steering effort. DTC No. DTC Detection Co ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR DRIVE SHAFT SNAP RING (a) Using a screwdriver, remove the rear drive shaft snap ring. 2. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP (a) U ...

Short in GPS Antenna (B15C0,B15C1)
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 Navigation antenna malfunction ...