Toyota Venza manuals

Toyota Venza: Rear seats


Seatback angle adjustment lever

Pull up the lever until the lock is completely released.

Folding down the rear seatbacks

 - Before folding down the rear seatbacks


Stow the seat belt buckles and lower the head restraints to the lowest position.


Pass the outer seat belts and plates through the seat belt hangers.

This prevents the shoulder belt from being damaged.

Make sure that the seat belts are removed from the hangers before using them.

 - Folding down the rear seatbacks

From inside


Fold down the seatback while pulling the seatback angle adjustment lever.

Pull up the lever until the lock is completely released.

From outside


Pull the lever.

1. For left side rear seatback 2. For right side and center rear seatback

CAUTION

 - Seat adjustment

Do not recline the seat more than necessary when the vehicle is in motion, to reduce the risk of sliding under the lap belt. If the seat is too reclined, the lap belt may slide past the hips and apply restraint forces directly to the abdomen or your neck may contact the shoulder belt, increasing the risk of death or serious injury in the event of an accident.

- Before folding down a rear seat

Do not fold down a rear seat when there are passengers sitting in the rear seats or when there is luggage placed on the rear seats.

- When returning the seatbacks to their original position

Observe the following precautions. Failure to do so may result in death or serious injury.

• Be careful not to get your hands pinched in the seat.

• Make sure the seatbacks are securely locked by lightly rocking it back and forth.

• Check that the seat belts are not twisted or caught under the seat.

• Arrange the seat belts in the proper positions for ready use.

NOTICE
 - When folding down the rear seatbacks

The seat belts and buckles must be stowed.

Front seats
► Power seat 1. Seat position fore/aft control switch 2. Seatback angle control switch 3. Seat cushion (front) angle control switch (driver’s side only) 4. Vertical height control switch ...

Driving position memory
Your preferred driving position (the position of the driver’s seat and angle of the outside rear view mirrors) can be memorized and recalled by pressing a button. It is also possible to set this ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE RECLINING POWER SEAT SWITCH KNOB 6. REMOVE SLIDE AND VER ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: When installing the mouldings, heat the vehicle body and mouldings using a heat light. Heating Temperature Item Temperature Vehicle Body 40 to 60°C (104 to 140 ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY (a) Engage the 8 clamps. (b) Engage the 2 claws and connect the fuel lid lock control cable sub-assembly. 2. INSTALL FUE ...

© 2016-2024 Copyright www.tovenza.com

0.1649