DESCRIPTION
The No. 1 ultrasonic sensor (rear right sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear right sensor). If the No. 1 ultrasonic sensor (rear right sensor) has an open circuit or other malfunction, it will not function normally.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1AE9 |
A malfunction of the No. 1 ultrasonic sensor (rear right sensor). |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and turn the clearance sonar main switch on. Then clear the DTCs (See page ).
PROCEDURE
1. |
CHECK DTC OUTPUT |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
Only DTC C1AE9 is output |
A |
DTC C1AE9 and C1AED are output |
B |
No DTCs are output |
C |
B |
GO TO DTC (C1AED) |
C |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR) |
(a) Replace the No. 1 ultrasonic sensor (rear right sensor) with a known good one (See page ).
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC C1AE9 is output |
A |
No DTCs are output |
B |
A |
REPLACE CLEARANCE WARNING ECU ASSEMBLY |
B |
END |
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE INTAKE VALVE GUIDE BUSH
(a) Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
(b) Place the cylinder head on wooden blocks.
(c) Using SST and a hammer, tap out the valve guide bush.
SST: 0 ...
Open / Short in Steering Lock ECU (B2781)
DESCRIPTION
If the steering lock ECU (steering lock actuator assembly) determines that there
is a malfunction inside the ECU, it outputs this DTC. Diagnostic communication between
the steering lock ECU (steering lock actuator assembly) and the Techstream ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR NO. 3 SPEAKER ASSEMBLY (for 13 Speakers)
(a) With the speaker installed, check that there is no looseness or other abnormalities.
(b) Check that there is no foreign matter in the speaker, no tears on the speaker
cone ...