DESCRIPTION
The No. 1 ultrasonic sensor (rear right center sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear right center sensor). If the No. 1 ultrasonic sensor (rear right center sensor) has an open circuit or other malfunction, it will not function normally.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1AE8 |
A malfunction of the No. 1 ultrasonic sensor (rear right center sensor). |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and turn the clearance sonar main switch on. Then clear the DTCs (See page ).
PROCEDURE
1. |
CHECK DTC OUTPUT |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
Only DTC C1AE8 is output |
A |
DTC C1AE8 and C1AED are output |
B |
No DTCs are output |
C |
B |
GO TO DTC (C1AED) |
C |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR) |
(a) Replace the No. 1 ultrasonic sensor (rear right center sensor) with a known good one (See page ).
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC C1AE8 is output |
A |
No DTCs are output |
B |
A |
REPLACE CLEARANCE WARNING ECU ASSEMBLY |
B |
END |
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small
opening of a new No. 2 steering rack boot.
(b) Install the No. 2 ste ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR CONSOLE ARMREST ASSEMBLY
(a) Temporarily install the rear console armrest assembly.
(b) Push in the box door hinge shafts by hand as far as possible.
HINT:
The illustration is for the LH sid ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 CONSOLE BOX CARPET
(a) Remove the No. 1 console box carpet.
2. REMOVE INSTRUMENT PANEL CUP HOLDER DAMPER
(a) Pull the instrument panel cup holder da ...