Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
If both the left and right side hoses are removed at the same time, be sure to place identification marks indicating the position on each side.
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.
3. REMOVE REAR FLEXIBLE HOSE
(a) Remove the union bolt and gasket, and separate the rear flexible hose. |
|
(b) Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench. Text in Illustration
NOTICE:
|
|
(c) Remove the clip.
(d) Remove the bolt and rear flexible hose from the absorber bracket. |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. INSTALL REAR FLEXIBLE HOSE
(a) Connect the rear flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket. Torque: 29 N·m {300 kgf·cm, 22 ft·lbf} HINT: Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly. |
|
(b) Install the rear flexible hose to the bracket with a new clip.
NOTICE:
Install the clip as far as it will go.
(c) Using a union nut wrench, connect the brake line to the rear brake flexible hose while holding the flexible hose with a wrench. Text in Illustration
Torque: Specified Tightening Torque : 15 N·m {155 kgf·cm, 11 ft·lbf} NOTICE:
HINT:
|
|
(d) Install the rear flexible hose to the absorber bracket with the bolt. Torque: 19 N·m {192 kgf·cm, 14 ft·lbf} |
|
2. FILL RESERVOIR WITH BRAKE FLUID
3. BLEED BRAKE LINE
4. INSPECT FOR BRAKE FLUID LEAK
5. INSPECT FLUID LEVEL IN RESERVOIR
6. INSTALL REAR WHEEL
Torque:
103 N·m {1050 kgf·cm, 76 ft·lbf}
Air Inlet Damper Control Servo Motor Circuit (B1442/42)
DESCRIPTION
The air inlet control servo motor sends pulse signals to indicate the damper
position to the A/C amplifier. The A/C amplifier activates the motor (normal or
reverse) based on these signals to move the air inlet mode selection air inlet control ...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SEAT ADJUSTER COVER CAP RH
(a) Using a screwdriver wrapped with protective tape, disengage the 3
claws and remove the seat adjuster cover cap RH.
Text in Illustration
*1
...