Toyota Venza: Rear Axle Carrier(for Awd)

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE CARR ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE YAW RATE AND ACCELERATION SENSOR HINT: Refer to the instructions for Removal of the yaw rate and acceleration sensor (See page ). 2. REMOVE REAR NO. 2 AIR DUCT 3. REMOVE REAR NO. 1 AIR DUCT 4. REMOVE FRONT NO. 2 FLOO ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH (a) Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rear bumper plate LH. Text in Illustration *1 Pro ...

Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSFER ASSEMBLY (a) Install the transfer assembly to the automatic transaxle assembly with 2 new bolts and the 6 nuts. Torque: 69 N·m {700 kgf·cm, 51 ft·lbf} NOTICE: Install the ...