READINESS MONITOR DRIVE PATTERN
1. PURPOSE OF READINESS TESTS
HINT:
Many state Inspection and Maintenance (I/M) programs require the status of vehicle Readiness Monitor to show Complete before beginning emission tests.
CAUTION:
Strictly observe posted speed limits, traffic laws, and road conditions when performing these drive patterns.
NOTICE:
These drive patterns represent the fastest method of satisfying all conditions necessary to achieve complete status for each specific Readiness Monitor.
In the event of a drive pattern being interrupted (possibly due to factors such as traffic conditions), the drive pattern can be resumed. In most cases, the Readiness Monitor will still achieve complete status upon completion of the drive pattern.
To ensure completion of the Readiness Monitors, avoid sudden changes in vehicle load and speed (driving up and down hills and/or sudden acceleration).
2. VVT SYSTEM MONITOR
(a) Refer to Confirmation Driving Pattern [P0011] (See page ).
(b) Refer to Confirmation Driving Pattern [P0014] (See page ).
3. CATALYST MONITOR (ACTIVE AIR FUEL RATIO CONTROL TYPE)
(a) Refer to Confirmation Driving Pattern [P0420] (See page ).
4. EVAP SYSTEM MONITOR (KEY OFF TYPE)
(a) Refer to Confirmation Driving Pattern [EVAP System] (See page ).
5. AIR FUEL RATIO AND HEATED OXYGEN SENSOR MONITORS (ACTIVE AIR FUEL RATIO CONTROL TYPE)
(a) Refer to Confirmation Driving Pattern [P0136] (See page ).
(b) Refer to Confirmation Driving Pattern [P2195] (See page ).
6. AIR FUEL RATIO AND HEATED OXYGEN SENSOR HEATER MONITORS (FRONT AIR FUEL RATIO AND REAR HEATED OXYGEN SENSOR TYPE)
(a) Refer to Confirmation Driving Pattern [P0031] (See page ).
(b) Refer to Confirmation Driving Pattern [P0037] (See page ).
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Smart Key. Main Body or Power
Source Control / Trouble Codes.
(e) Ch ...
Headlight switch
The headlights can be operated manually or automatically.
Turning the end of the lever turns on the lights as follows.
Type A
The daytime running lights turn
on.
The headlights, parking lights, daytime running lights and so on turn on and
off auto ...
Wireless-linked Return Function does not Operate
DESCRIPTION
When the vehicle doors are unlocked through wireless unlock or entry unlock*1
operation, the certification ECU (smart key ECU assembly)*1 or main body ECU (driver
side junction block assembly) sends the key ID signal and memory call request si ...