PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Axle System
Symptom |
Suspected Area |
See page |
---|---|---|
Wander or pulls |
Tires (worn or improperly inflated) |
|
Front wheel alignment (incorrect) |
|
|
Rear wheel alignment (incorrect) |
|
|
Steering intermediate shaft (loose or worn) |
|
|
Front hub bearings (loose or worn) |
|
|
Rear hub bearings (loose or worn) (for 2WD) |
|
|
Rear hub bearings (loose or worn) (for AWD) |
|
|
Steering gear (broken) (for 1AR-FE) |
|
|
Steering gear (broken) (for 2GR-FE) |
|
|
Suspension parts (worn out) |
- |
|
Front wheel shimmy |
Tires (worn or improperly inflated) |
|
Wheels (out of balance) |
|
|
Shock absorber (worn out) |
|
|
Front wheel alignment (incorrect) |
|
|
Lower ball joint (worn) |
|
|
Axle hub bearings (loose or worn) |
|
|
Steering intermediate shaft (loose or worn) |
|
|
Steering gear (broken) (for 1AR-FE) |
|
|
Steering gear (broken) (for 2GR-FE) |
|
|
Rear wheel shimmy |
Tires (worn or improperly inflated) |
|
Wheels (out of balance) |
|
|
Shock absorber (worn out) |
|
|
Axle hub bearings (loose or worn) (for 2WD) |
|
|
Axle hub bearings (loose or worn) (for AWD) |
|
|
Rear wheel alignment (incorrect) |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the wire harness clamp with the bolt.
Torque:
8.4 N·m {86 kgf·cm, 74 in·lbf}
(b) Install the 2 bolts.
Torque: ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves when removing the exhaust pipe.
The exhaust pipe is extremely hot immediately after the engine has stopped.
Confirm that the exhaust pipe has cooled down ...
Push Switch / Key Unlock Warning Switch Malfunction (B2780)
DESCRIPTION
This DTC is stored if the transponder key ECU assembly does not detect that the
unlock warning switch assembly is ON even when the ignition switch is ON. Under
normal conditions, the unlock warning switch assembly is ON when the ignition switc ...