Toyota Venza: Problem Symptoms Table

HINT:

• Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
• Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Registration

REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION HINT: The key has 2 codes: the key code (immobiliser code) and the wireless code. Both of these codes need to be registered. For the wi ...

Diagnosis System

DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the vehicle's immobiliser system functions. Immobiliser system data and Diagnostic Trouble Code (DTC) can be read ...

Other materials about Toyota Venza:

Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)
DESCRIPTION Refer to DTC P2714 (See page ). DTC No. DTC Detection Condition Trouble Area P2716 Open or short is detected in shift solenoid valve SLT circuit for 1 second or more while driving ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof) 2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof) 3. REMOVE VANITY LIGHT ASSEMBLY (a) Remove the vanity light assembly (See page ). HINT: Use the same p ...

Audio Receiver Assembly Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Audio Receiver Assembly Communication Stop Mode "Display and Navigation (AVN1)" is not displayed on the "CAN Bus Check ...